The plasma cutting process is a process used to cut the metal material in an efficient manner which gives a sharp & clean cut look in the less possible time. This process is far better than that of the other cutting like gas cutting etc. processes. It takes less time, does not demand maintenance, and gives the best-finished cut. When we compare it with the other cutting like gas cutting etc processes, plasma arc cutting always turns out to be the best.
Some of the reasons why it is considered the best above others are it can be used on a variety of electrically conductive materials. It makes no contact with the material that needs to be cut. The machines are safer for the workers; it requires less energy, minimum hazards, and many more. This cutting process has helped in improving the worker’s efficiency as well as it consumes less time in finishing the task. While using this process, often a question arises of how one can get the best quality plasma cut. One must know that plasma cutter tips offer several solutions to help improve the cut quality on the metal plate. These tips are designed to cut any metal on the CNC table. Know that one should consider some factors to get the best results. Some of the factors are a type of machine, cutting system, motion control device, process, and external variables.
Following are some of the questions you should consider to get the best quality plasma cut:
- Is the plasma arc cutting in the right direction- Make sure to find the appropriate position of the plasma arc while cutting the metal material to get the finished cut. If not, then change or adjust the settings of the cutting direction. As the plasma arc spins clockwise, the torch will travel the same, so that means the good side of the cut is towards the right side of the torch.
- Was the plasma cutting setting selected as per the thickness- The specifications must be looked into while adjusting the settings as per the metal material and thickness. Also, decide the cutting speed and go with the right tips to get the desired quality cut.
- Are the plasma tips not in good condition- It is important to check the plasma tips and replace them if they are worn out. It is important to do so for the desired quality cut. Also, do not use them.
- Check the cutting speed- You need to know about the quality you want and the time limit you want the process to complete. The ratio of optimum cutting speed & cut qualityneeds to be established with manufacturers guide & practical work experience
- Check whether the torch is placed at the proper height- Make sure to adjust the height of the torch. If the torch is too low, there will be a negative cut angle, and if the torch is too high, there will be a positive cut angle.
So above are some of the pointers you should go for to get the best quality plasma cut. Also, the get the best quality plasma arc welding machinery, you should contact ‘Taiwan plasma corporation’ as they are the best manufacturers of plasma cutting with a rich experience of 33 years and certified suppliers, recognised globally.
